11-Pin Hub Motor Extension Cable - Fits Bafang G063 1000W
11-Pin Hub Motor Extension Cable - Fits Bafang G063 1000W
Does it fit your bike?
- Fits Bafang G063 1000W hub motors (11-pin plug, Bafang code G11.6)
- Fits Other hub motors with the same red 11-pin screw-lock plug (match by photo)
- Not for 9-pin and 10-pin motor plugs
- Not for 11-pin plugs of a different shape
Bafang's G063 1000W fat-tire hub motor uses a red 11-pin screw-lock plug, listed by Bafang as connection type G11.6. This extension cable has a female socket on one end and a male plug with a screw collar on the other, and sits between the motor lead and the controller to replace a damaged lead or add reach.
Key facts as stated by the manufacturer: 11 pins, female to male, 50 cm (about 19.7 in), waterproof connectors, tinned copper wire in a PVC jacket, rated for motors up to 1000 W and 48 V. The manufacturer says it fits Bafang G063 1000W hub motors. Three 12 AWG phase wires and six 24 AWG signal wires are connected; two small signal positions are empty.
Check before you order: it only mates with the red 11-pin screw-lock plug, not 9-pin, 10-pin or other 11-pin shapes. It is a straight extension, not an adapter, and not for mid-drive motors. If your controller uses a motor temperature sensor, send us a wiring photo first.
Installation takes about 10 minutes: switch the battery off, unplug the motor lead, connect the cable in between, screw each collar down fully and zip-tie the cable away from the brake rotor.
Not sure it fits? Email photos to support@riderow.com and we'll check before you order.
Specs & fit
Key specs
| Voltage | Up to 48V |
|---|---|
| Power | Up to 1000W (manufacturer-stated) |
| Connector | 11-pin waterproof screw-lock, female socket one end / male plug with screw collar other end |
| Pins | 11 |
| Pinout |
|
| Cable length | 500 mm (19.7 in) |
| Waterproof | Waterproof connectors (manufacturer-stated) |
Compatibility
Compatible with
- Fits Bafang G063 1000W hub motors (11-pin plug, Bafang code G11.6)
- Other hub motors with the same red 11-pin screw-lock plug (match by photo)
Not compatible with
- 9-pin and 10-pin motor plugs
- 11-pin plugs of a different shape
- Mid-drive (BBS) motors
- Systems above 48V
In the box
- 1 x 11-pin motor extension cable, 50 cm
Install
- Difficulty
- Easy
- Time
- 5-10 min
- Tools
- Zip ties
Before you order
- 1) Close-up of the plug on the motor lead showing the red 11-pin face and the screw collar.
- 2) Close-up of the controller's motor socket.
- 3) Photo of the motor label (model code such as G063.1000).
Shipping
Ships from a US warehouse, usually within 2-4 business days
Data source: Manufacturer spec