Full-Twist Throttle Grip, 3-Pin Waterproof Plug, 22.2 mm
Full-Twist Throttle Grip, 3-Pin Waterproof Plug, 22.2 mm
Does it fit your bike?
- Fits E-bike controllers with a 3-pin throttle plug of matching wire order
- Fits 22.2 mm handlebars, right-hand side
- Not for 2-pin or 5-pin throttle plugs
- Not for Plugs with a different wire order
A worn rubber grip, a throttle that sticks or one that gives no signal can all be fixed with a new full-twist throttle. This grip twists to give proportional speed control and replaces the right-hand grip. It ends in a 3-pin waterproof plug on a 310 mm cable.
Key facts as stated by the manufacturer: made for 22.2 mm handlebars, installed on the right side, rubber and ABS construction with a non-slip surface, 310 mm cable, listed for 12 V to 72 V controllers. A hex wrench is included.
Check before you order: the wire order of the plug has to match your controller, and the manufacturer warns that the throttle will not work if it does not. The pin-to-wire order is not published, so compare the plug with your old throttle and send us a photo if you are unsure. Confirm that your plug is 3-pin and that your bar is 22.2 mm. It is not for 2-pin or 5-pin plugs, left-hand mounting or thumb-throttle setups.
Installation takes about 15 minutes: disconnect the battery, remove the right grip and brake lever clamp as needed, fit the throttle, secure the cable and test with the wheel raised.
Not sure it fits? Email photos to support@riderow.com and we'll check before you order.
Specs & fit
Key specs
| Connector | 3-pin waterproof plug |
|---|---|
| Pins | 3 |
| Cable length | 310 mm (12.2 in) |
| Clamp diameter | 22.2 mm (0.87 in) |
Compatibility
Compatible with
- E-bike controllers with a 3-pin throttle plug of matching wire order
- 22.2 mm handlebars, right-hand side
Not compatible with
- 2-pin or 5-pin throttle plugs
- Plugs with a different wire order
- Left-hand mounting
In the box
- 1 x full-twist throttle grip with 3-pin plug
- 1 x hex wrench
Install
- Difficulty
- Moderate
- Time
- 15 min
- Tools
- Hex key (supplied), Zip ties
Before you order
- 1) Close-up of the plug on your current throttle (pin count, male or female, plug color).
- 2) The point where the throttle cable meets the harness.
- 3) Measurement of your handlebar (should read 22.2 mm).
Data source: Manufacturer spec