Brake Lever Pair with 2-Pin Power Cut-Off, 22 mm Bar
Brake Lever Pair with 2-Pin Power Cut-Off, 22 mm Bar
Does it fit your bike?
- Fits E-bikes with a 2-pin brake motor cut-off plug
- Fits Mechanical (cable-pull) brakes
- Fits 7/8 in (22 mm) handlebars
- Not for Hydraulic brakes
- Not for 3-pin or 5-pin cut-off plugs
Our fit guarantee covers parts we confirm from your photos (free). Without that check, electrical parts can't be returned once connected.
Not sure? Send photos — we check before you payWhen an e-bike brake lever is bent, cracked or no longer cuts the motor, this pair replaces both sides in one go. The levers carry a 2-pin waterproof motor cut-off connection, so pulling a lever tells the controller to stop driving the motor. They fit 7/8 in (22 mm) handlebars.
Key facts as stated by the manufacturer: a solid aluminum alloy core (not hollow) with an anodized matte finish, 7/8 in or 22.5 mm handlebar clamps, comfortable V-brake style grip, for mechanical disc brakes. The pack contains the lever pair and two brake cables and weighs 0.35 kg.
Check before you order: this is a cable-pull (mechanical) lever. It is not for hydraulic brakes. Look at the cut-off plug on your bike: it has to be a 2-pin plug, and the manufacturer does not say whether it is male or female or what shell shape it is, so send a photo. Handlebars must be 22 mm.
Installation takes about 30 minutes: disconnect the battery, remove the grips and old levers, fit the new pair, thread the cables, adjust the brake and plug the cut-off leads in.
Not sure it fits? Email photos to support@riderow.com and we'll check before you order.
Specs & fit
Key specs
| Connector | 2-pin waterproof cut-off plug (shell shape not stated) |
|---|---|
| Pins | 2 |
| Clamp diameter | 22.2 mm (0.87 in) |
| Weight | 350 g (12.3 oz) |
Compatibility
Compatible with
- E-bikes with a 2-pin brake motor cut-off plug
- Mechanical (cable-pull) brakes
- 7/8 in (22 mm) handlebars
Not compatible with
- Hydraulic brakes
- 3-pin or 5-pin cut-off plugs
- Handlebars other than 22 mm
In the box
- 2 x brake levers (left and right) with cut-off leads
- 2 x brake cables
Install
- Difficulty
- Moderate
- Time
- 30 min
- Tools
- Hex key set, Screwdriver, Zip ties
Before you order
- 1) Close-up of the cut-off plug on your current brake lever (pin count, male or female).
- 2) The levers on the handlebar, seen from above.
- 3) Measurement of your handlebar diameter.
Data source: Manufacturer spec